Numerical study of choked two-phase flow of hydrocarbons fluids through orifices

Valves and orifices are the most widely devices of flow control used in oil and gas industry. In particular, they are installed in relief piping system in order to control the discharge flow during potential plant overpressuring scenarios, thus ensuring plant safety. It is a common practice to flow liquid and gas mixtures through such restriction devices.Rigorous models are available to precisely size pressure relief devices operating in single phase flow; however for two-phase flow, no models are considered sufficiently reliable for predicting the relevant flow conditions.In the present paper, two-phase flow of hydrocarbons fluids through an orifice under critical conditions has been numerically investigated.The existing literature has been analyzed and data on two-phase flow of highly volatile mixtures of hydrocarbons through openings have been collected. A comparison has been carried out with numerical simulations carried out by the multiphase flow simulation tool OLGA by SPT.The Henry-Fauske model has been used as orifice choke model and the orifice discharge flow coefficient, required as input by OLGA, has been calculated by Chisholm's model.Comparison between OLGA's results and experimental data shows that Henry-Fauske model markedly underestimates the mass flow rate through the orifice, if Chisholm's model is used to calculate discharge coefficient. It was found that the error of the model could be minimized using different values of orifice discharge coefficient (Cd).A new discharge flow coefficient model, suitable for choked two-phase flow across orifices, is proposed in this study and it has been determined to match the above mentioned experimental measurements.